Replace light bulbs

 All the bulbs are in the electrical room. Cross the foyer corridor door opposite the front desk. The door with the pin code lock.

1. Living Room ceiling light

What you need: 

E27 led light bulb. Warm white. 6W - 10W.



Ladder. From basement storage room. - Small room next to the lift area.

There are 3 clips holding the light cover. One of them can be pulled out and you will be able to take the cover off. 



Unscrew the old bulb and replace with the new one. 

Have a test and wipe clean the cover before you put it back.


2. Kitchen ceiling light

What you need:

32W circular lamp



Starter (from the electrical room)


Ladder.

Take the light cover off by turning it anticlockwise.
Please note sometimes this can be a bit difficult when the cover has grease in there or jammed inside. When this happens you can try to pat and push the cover anticlockwise with care.






Take the old Starer out by turning it anticlockwise.
Pull the starer connector out. 
Then take the lamp out of the bracket.

Replace the new lamp by putting in the bracket.
Install the new starter and connect to the lamp.
Put the cover back on and it should be all good to go.












Comments

Post a Comment

Popular posts from this blog

Aircon Troubleshooting Guide

Image
  Aircon Troubleshooting: If the aircon controller displays an A4 error code or the unit is not cooling properly ,  please try the following steps: Method 1: Power cycle the circuit. The circuit is located in the bedroom wardrobe (03 units in the cabinet outside the bathroom). The aircon circuit is usually the 4th switch from the left . Turn it off, wait for a couple of minutes, and then turn it back on. Method 2: Using the dedicated Allen key found in the office toolbox , open the ceiling aircon system cover. Then, operate the two pipe valves (as shown in the picture) several times (at least 6 cycles). This procedure helps to clear the pipes and may restore proper cooling. Method 3: If Methods 1 and 2 do not work, the aircon may require a hardware reset . To perform this, open the control panel located on the opposite side of the two valves mentioned above. On the control board, there is a black reset button — press and hold this button to reset the system. If none o...
Read more

Troubleshooting: Landline Cannot Be Connected

Image
 Troubleshooting: Landline Cannot Be Connected Identifying the Issue: If it's observed that our landline cannot be connected, especially if no phone calls have been received in the past 2 hours, I highly suggest to make a test call to our landline number: 07 5557 7500. This helps confirm if the issue is with incoming calls. When there's a connection issue please  Reboot the VoIP Device located in the office: Unplug the device, wait for a minute, and then re-plug it in. In most cases, rebooting the VoIP device should resolve the landline connection issue. If problems persist, further investigation may be necessary.
Read more

Troubleshooting: Internet Connection

Image
When guests encounter an internet connection issue, follow these steps to troubleshoot: Check Maldives Public Wifi: First, try to connect to the Maldives Public Wifi on your own phone to determine if it's a guest device issue or a problem with our building's connection. If you can connect to the Maldives Public Wifi on your phone, it may be a guest device issue. If you can't connect on your phone either, it could be an issue with our building's internet connection. - If it's a guest device issue, and your device can connect but the guest's device cannot, follow these steps to troubleshoot: Forget the Wifi and Reconnect: Ask the guest to forget the Wifi network on their device and then attempt to reconnect. This often resolves connection issues. Reboot the Device: If the issue persists, instruct the guest to reboot their device. Restarting the device can help resolve connectivity problems. If both of these steps do not resolve the issue, provide the guest wit...
Read more